User`s manual

25
4-7 Applying the Completed Cutout
Once cutting has been completed, follow the procedure below for application instructions.
• Make sure beforehand that the surface where the work is to be stuck is clean and free of all dust or oily deposits.
• When applying the work to a transparent surface, such as a window, you can use a water-based pen (which can be
wiped off afterwards) to mark guidelines on the reverse side of the glass, to aid in getting the work aligned properly.
• If you discover after it is stuck in place that air bubbles were trapped under the work, use a needle to puncture them.
Then you can smooth out the material out so that it sticks securely.
2
Strip/Weed uses all unneeded portions from the
completed work.
3
Stick application tape over the completed work.
Press down firmly on the application tape to remove
air bubbles. If you do not press firmly enough the cut
area will not stick to the surface.
* You should have weed boarders or rectangles
drawn around work to facilitate weeding.
1
With the CM-500/400/300, the portion where you've performed cutting is automatically cut off from the material.
Press the key to cut off the portion from the material.
If you want to remove the material, then open the front cover, press down the sheet loading levers, and then remove the material.
4
Transfer the material to the application tape, position it, and carefully
affix it, making sure that it is aligned correctly. Rub over the applica-
tion tape to make sure the work is firmly stuck in place. Then peel off
the application tape.