User`s manual

6 Using the Display Menus

This section describes the basic steps for using the display menus. Use this information together with "7 Display Menus Flowchart" on

the following page to make menu settings.

1 CUT 50cm/s

0.250mm 30gf

AREA AXIS

REPLOT SUBMENU

ENTER

Press the key to change to

the next menu

AREA LENGTH

MOVE <1.0m>

ROTATE

<0deg> 90deg

ENTER

Then use the and keys to change the value and

enable the setting by pressing the key

Use the and keys to move the

blinking cursor (" ") and choose a setting

Press the key to advance

to the next setting screen

Select "AREA"

The value enclosed in angled brackets ("<>") is the current setting

The selection enclosed in angled brackets ("<>") is the current setting

Use the and keys to move the blinking cursor (" ") and choose a setting.

Then use the and keys to change the value (or the selection) and enable the setting by pressing the key.

Use the and keys to move the blinking cursor

(" ") and choose a setting

• To return to the menu selection screen from any of the menu value setting screens, press the

key.

• To return to the previous screen without changing the numerical settings, pressing the

key without

pressing the

ENTER

key.