User Manual

23
Mac OS X Users
Steps to be performed on the OCTA-CAPTURE keyboard itself are marked by a
Operation of the OCTA-CAPTURE
symbol. Don’t connect the OCTA-CAPTURE to your computer
until you are told to do so.
* What you actually see on the screen may dier depending on your system.
Installing the Driver
* During the installation process, when you are presented with a dialog box asking you to supply
your password, enter an administrator’s password and click [OK] or [Install Software]..
1. With the OCTA-CAPTURE disconnected, start up your computer.
Disconnect all USB cables from your computer, with the exception of those for a USB keyboard and
USB mouse (if used).
2. Close all currently running software.
3. Insert the included OCTA-CAPTURE CD-ROM into your DVD-ROM drive.
4. Double-click the OctaCapture_USBDriver.mpkg of MacDriver folder on the CD-ROM to
start up the installer.
A message concerned with checking whether installation is possible may appear.
If so, click [Continue].
If a message indicating that installation is not possible appears, check the operating system you’re
using, and perform step 4.
5. The screen will indicate “Welcome to the OCTA-CAPTURE Driver Installer.” Click
[Continue].
6. If the screen asks you to select a destination, click your start-up disk to select it, and
then click [Continue].
7. When the display asks you to select the type of installation, click [Install] or [Upgrade].
8. In the next screen, click [Continue Installation].
9. When installation is completed, click [Restart] to restart your computer.
* It may take some time for your computer to restart.
10.
Operation of the OCTA-CAPTURE
Once your computer has started up, check to make
sure that the OCTA-CAPTURE’s power is turned o, then use a USB cable to connect it
to your computer.
11.
Operation of the OCTA-CAPTURE
Switch on the OCTA-CAPTURE’s power (p. 31).