User Manual

10
Setup
Mounting on a Stand
By using a speaker stand (ST-
A95:sold separately ), you can
mount the CUBE Street EX at
the optimal height for use as a
monitor speaker or simple PA
device.
NOTE
* Always have at least one
other person assist you when
mounting the CUBE Street EX
on a speaker stand, or when
adjusting the height of the stand
while the CUBE Street EX remains mounted on it.
* Be careful not to pinch your ngers, when you assemble.
1. Loosen the tripod knob and open the tripod.
After opening the tripod wide enough,
tighten the tripod knob again.
* The distance between lower ends of the tripod
should be 98 cm (38-5/8”) as shown in right
gure. If the tripod is not opened wide enough,
the stand may be unstable.
2. Loosen the height adjustment knob
and make the upper tube longer.
3. Set up the upper tube at the required
height less than 130 cm (51-3/16”) and insert the stopper
into the hole of the upper tube.
* Always use the ST-A95 with the stopper inserted into the upper tube.
4. Tighten the height adjustment knob.
5. Fit the hole on the CUBE Street EX onto the upper tube.
Connecting Two Units to Increase the
Output (STEREO LINK)
You can use two CUBE Street EX units to increase the output. This
function is called “STEREO LINK.” You’ll need to provide one or two
phone (monaural) cables depending on how you use this function.
Connection When Using the Input Jacks of
Only One Unit
L-side R-side
INPUT
AUDIO IN
LINE IN
1. On the L-side unit and the R-side unit, set the [LINE OUT/
STEREO LINK] switch to “STEREO LINK.”
2. Connect the STEREO LINK OUT R jack on the L-side unit and
the STEREO LINK IN jack on the R-side unit.
* If you want to use the input jacks of the R-side unit, connect the STEREO
LINK OUT L jack of the R-side unit to the STEREO LINK IN jack of the L-side
unit.
3. Connect your guitars or mics to the input jacks of the L-side
(R-side) unit.
Connections When Using the Input Jacks
of Both Units
L-side R-side
INPUT
AUDIO IN
LINE IN
INPUT
AUDIO IN
LINE IN
1. On the L-side unit and the R-side unit, set the [LINE OUT/
STEREO LINK] switch to “STEREO LINK.”
2. Connect the STEREO LINK OUT R jack on the L-side unit and
the STEREO LINK IN jack on the R-side unit.
3. Connect the STEREO LINK OUT L jack on the R-side unit and
the STEREO LINK IN jack on the L-side unit.
4. Connect your guitars and mics to the input jacks.
Adjusting the Volume
Adjust the L and R volume levels using their [VOLUME] knobs.
Upper tube
Tripod
knob
Height adjustment
knob
Stopper
Tripod
ST-A95
Leg spread:
98 cm (38-5/8”)
or more