User Manual

ManualsBrandsRoland ManualsPad for Electronic BatteriesCY-15R V-Cymbal Ride

Owner’s Manual

Thank you and congratulations on your choice of the Roland V-Cymbal CY-15R/CY-14C/CY-12H.

Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” (p. 2) and

“IMPORTANT NOTES” (p. 3). These sections provide important information concerning the proper

operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every

feature provided by your new unit, Owner’s manual should be read in its entirety. The manual should be

saved and kept on hand as a convenient reference.

permission of ROLAND CORPORATION.

Before You Begin

When using a TD-10:

Make sure you are using a TDW-1 version that includes “with V-Cymbal Control”

(see p. 4).

2. Select TRIGGER BANK 2 in the TD-10 for use with the V-Cymbals (see p. 9).

* If you are using another sound module, you have to set the trigger parameters. Refer to “Trigger Parameter Settings

for the Sound Module (p. 10).”

How to mount the CY-15R (Ride)/CY-14C (Crash)

fig.01.e

Stopper

(Be sure to orient

it correctly)

Tighten the nut with a commercially

available drum key

Felt Washer

Position the Roland

logo on the opposite

side of the playing area

Wing Nut

(Tighten it to obtain the desired movement)

* For more details, refer to p. 6.

02457101 ’05-6-6N

CY-15R

CY-14C

CY-12H

V-Cymbal Ride

V-Cymbal Crash

V-Cymbal Hi-Hat

CY-12H/14C/15R.e 1 ページ２００５年５月１９日　木曜日　午後２時１２分

Summary of content (14 pages)

PAGE 1
CY-12H/14C/15R.e 1 ページ２００５年５月１９日木曜日午後２時１２分 CY-15R V-Cymbal Crash CY-14C V-Cymbal Hi-Hat CY-12H V-Cymbal Ride Owner’s Manual Thank you and congratulations on your choice of the Roland V-Cymbal CY-15R/CY-14C/CY-12H. Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” (p. 2) and “IMPORTANT NOTES” (p. 3). These sections provide important information concerning the proper operation of the unit.
PAGE 2
CY-12H/14C/15R.e 2 ページ２００５年５月１９日木曜日午後２時１２分 USING THE UNIT SAFELY The symbol alerts the user to important instructions or warnings.The specific meaning of the symbol is determined by the design contained within the triangle. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger. Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly.
PAGE 3
CY-12H/14C/15R.e 3 ページ２００５年５月１９日木曜日午後２時１２分 IMPORTANT NOTES 291a In addition to the items listed under “USING THE UNIT SAFELY” on page 2, please read and observe the following: Placement 354b • Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes.
PAGE 4
CY-12H/14C/15R.e 4 ページ２００５年５月１９日木曜日午後２時１２分 Getting Started Features Similar touch and feel as with acoustic cymbals The superior design has taken into account not only the shape of the cymbal, but also the bounce of the stick, and even the movement caused by playing, making it possible to play with the same feel as an acoustic cymbal. They’re quiet! Rubber is used on the striking surface for a damping effect.
PAGE 5
CY-12H/14C/15R.e 5 ページ２００５年５月１９日木曜日午後２時１２分 Definitions & Names of Parts CY-15R (Ride) fig.02.e Wing Nut Felt Washer Stopper Bell Portion BOW/BELL OUTPUT Jack Bow Portion BOW/EDGE OUTPUT Jack Edge Portion Diameter: 15 inches CY-14C (Crash) fig.02a.e Wing Nut Felt Washer Stopper Bow Portion BOW/EDGE OUTPUT Jack Edge Portion * The CY-14C has no BOW/BELL OUTPUT Jack. Diameter: 14 inches CY-12H (Hi-Hat) fig.03.
PAGE 6
CY-12H/14C/15R.e 6 ページ２００５年５月１９日木曜日午後２時１２分 Mounting on the Stand CY-15R (Ride) CY-14C (Crash) CY-12H (Hi-Hat) fig.07 1. Use a commercially available drum key to tighten the stopper bolt. (A) The stopper keeps the V-Cymbal from turning, and prevents the cables from catching or getting tangled on the stand. fig.04.e Stopper (Be sure to orient it correctly) Tighten the bolt with a commercially available drum key (B) 2. Position the Roland logo on the farther side, as viewed from the performer. 3.
PAGE 7
CY-12H/14C/15R.e 7 ページ２００５年５月１９日木曜日午後２時１２分 Connecting to a Sound Module 921 * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. fig.08 Crash CY-14C Ride CY-15R Hi-Hat CY-12H TD-10 RIDE CRASH Use the supplied connection cables (stereo) to make the connections. If monaural cables are used, edge shots, bell shots, and choke play cannot be supported. The CY-14C has no BOW/BELL output.
PAGE 8
CY-12H/14C/15R.e 8 ページ２００５年５月１９日木曜日午後２時１２分 Playing Methods Bow Shot Choke Play This is the most common playing method, playing the middle area of the cymbal. It corresponds to the sound of the “head-side” of the connected trigger input. Choking (pinching) the cymbal’s edge with the hand immediately after hitting the cymbal makes the sound stop. Choke the location of the edge sensor shown in the figure. If you choke an area where there is no sensor, the sound does not stop. fig.09 fig.12.
PAGE 9
CY-12H/14C/15R.e 9 ページ２００５年５月１９日木曜日午後２時１２分 For TDW-1 with V-Cymbal Control Users Playing Different Sounds with the CY-15R’s Bow, Bell, and Edge (Three Way Triggering Feature) When you use the TDW-1 with V-Cymbal Control, which completely supports the V-Cymbal, three way triggering (bow, bell, and edge shot) performances that use both outputs on the CY-15R are possible. The Original version of the TDW-1 and the non-expanded TD-10 do NOT support three way triggering (p. 11).
PAGE 10
CY-12H/14C/15R.e 10 ページ２００５年５月１９日木曜日午後２時１２分 Trigger Parameter Settings for the Sound Module You may need to adjust the value since these are just the reference value. TD-10 (TDW-1 with V-Cymbal Control) TD-8 CY-12H CY-14C CY-15R Pad Type (Trigger Type) PD7 PD7 PD7 Sensitivity 10 10 10 CY-12H CY-14C CY-15R Threshold 3 3 3 Trigger Type HH CrB RdA Curve Linear Linear Linear Sensitivity 7 8 8 Scan Time 1.0 1.0 1.
PAGE 11
CY-12H/14C/15R.
PAGE 12
CY-12H/14C/15R.e 12 ページ２００５年５月１９日木曜日午後２時１２分 Troubleshooting Check these first Is the trigger type set correctly? Make the trigger parameter settings for your sound module. * Refer to “Trigger Parameter Settings for the Sound Module (p. 10).” Is a monaural cable being used? When a monaural cable is used, the sound does not change when an edge shot or a bell shot is made. Choke play is not possible, either. Use a stereo cable.
PAGE 13
CY-12H/14C/15R.e 13 ページ２００５年５月１９日木曜日午後２時１２分 Specifications CY-15R (Ride) Size: Trigger: 15 inches 3 (Bow/Bell/Edge) * When the TDW-1 with V-Cymbal Control is not being used, select “Bow/Bell” or “Bow/Edge.” Connectors: BOW/BELL Output Jack, BOW/EDGE Output Jack Dimensions: 376 (W) x 376 (D) x 50 (H) mm 14-13/16 (W) x 14-13/16 (D) x 2 (H) inches Weight: 1.
PAGE 14
CY-12H/14C/15R.e 14 ページ２００５年５月１９日 Information AFRICA EGYPT Al Fanny Trading Office 9, EBN Hagar A1 Askalany Street, ARD E1 Golf, Heliopolis, Cairo 11341, EGYPT TEL: 20-2-417-1828 REUNION Maison FO - YAM Marcel 25 Rue Jules Hermann, Chaudron - BP79 97 491 Ste Clotilde Cedex, REUNION ISLAND TEL: (0262) 218-429 SOUTH AFRICA That Other Music Shop(PTY)Ltd. 11 Melle St., Braamfontein, Johannesbourg, SOUTH AFRICA TEL: (011) 403 4105 FAX: (011) 403 1234 Paul Bothner(PTY)Ltd.