User Manual

28
Using Serato DVS
* If “Vinyl/CDJ Control” is not shown, double-click the [MY PRODUCTS]
tab in the my serato screen, and check whether “DVS EXPANSION” is
activated.
If the following screen appears, click [ACTIVATE].
5. Make sure that “Enable Vinyl/CDJ Control” has a check mark.
If it does not have a check mark, add a check mark.
When the Serato DVS Expansion is activated, the DJ-808’s sound card
mode switches to “DVS mode.” While the DJ-808 is in “DVS mode,” the
state is as shown below.
Wait until switching is complete (approximately one minute). When
switching is complete, the state is as shown below.
6. Close Serato DJ.
7. Turn o the power of the DJ-808, wait about one minute, and
then turn the power on again.
8. Restart Serato DJ.
Wait until the virtual deck with a VINYL control mode button appears.
* It may take some time until you see the virtual deck with the VINYL
control mode button.