User Manual

30
Using Serato DVS
* If the calibration deck is not shown, go to the SETUP screen’s
“EXPANSION PACKS” tab, select [Vinyl/CDJ Control], and make sure that
there is a check mark on “Enable Vinyl/CDJ control.”
* If the green circle is not shown on the scope, check the following items.
5 The turntable/DJ player is correctly connected with the DJ-808.
5 The ground wire of the turntable is connected to the DJ-808’s
PHONO GROUND terminal.
5. Make adjustments so that the green circle is a perfect circle.
L/R Balance Compensates for distortion in the vertical direction.
P/A Balance Compensates for distortion in the horizontal direction.
Zoom Enlarges the circle in the scope.
Noise Sensitivity If the control signal is below the value specied here, it is treated as noise.
Estimate
With the needle placed on the record of the stopped turntable, or with the
DJ player paused or stopped, holding down this button moves the “Noise
Sensitivity.”
* For details, refer to the Serato DJ owner’s manual.
6. Repeat steps 1–5 to adjust the control signal of all turntables or
DJ players.
Playing a Song with DVS
1. In the virtual deck screen, click the VINYL control mode button
to select either REL mode or ABS mode.
2. Import a song as described in “Importing a Song” (p. 11).
3. Load the song as described in “Loading a Song” (p. 11).
4. Operate your turntable or DJ player to play back the control
record or CD.
The song that’s loaded into the deck plays.
5. Move the channel fader upward and turn the [TRIM] knob
toward the right to adjust the volume.
Adjust the volume so that the channel level indicator’s OVER segment
does not light.
6. Turn the [MASTER LEVEL] knob toward the right to adjust the
level of the speakers.
Functions Available When Using DVS
When using DVS, the available functions are limited as follows.
Function REL mode ABS mode
Performance pads
Hot cue
(
(*1)
Roll
(
Slicer
(
Slicer loop
(
Sampler
( (
Velocity sampler
( (
Cue loop
(
Saved loop
(
Saved ip
(
Loop
Loop
(
Loop active
(
Loop half/double/shift
(
Loop in
(
Loop slot select
(
4 beat loop
(
Loop out
(
Re-loop
(
Loop exit
(
Transpose
Play/Pause/Stutter
Temporary cue
(
Sync
(
Jog dial
Scratch
Pitch bend
(
Skip
(
Tempo control
Tempo slider
Key lock
( (
Tempo reset
Tempo range
Flip
Flip rec
(
Flip loop
(
Flip start
(
Flip on/o
(
Flip slot select
(
Flip save
(
Others
Censor
(
Reverse play
Rec
(*1) Only hot cue settings are possible. Recall is not possible.