User Manual

9
Panel Descriptions
Rear Panel (Connecting Your Equipment)
XLR type
Phone type
TRS type
MIDI device
Audio player
DJ player
Turntable
(analog)
Turntable
(analog)
USB audio
compatible device
Powered speaker
Powered speaker, amp
Microphone
1 2 3 4 5 6
7 7
8
9 10 11 5
Front Panel
1 2 3 4 5
6
7 8
Headphones
1
[PHONES] jacks
Connect headphones here.
Stereo 1/4” (Ø 6.3 mm) and stereo 1/8” (Ø 3.5 mm) plugs are supported.
2
[VOLUME] knob
Adjusts the volume of the headphones.
3
[MIXING] knob
Adjusts the monitor volume balance of the channel whose Channel [CUE]
button is lit and the master output.
* This is functional if the [MONO SPLIT/STEREO] switch is set to STEREO.
4
[MONO SPLIT/STEREO] switch
Switches the headphone output between mono (MONO SPLIT) and stereo
(STEREO).
MONO SPLIT
The sound of the channel whose Channel [CUE] button is lit is heard from the
L-side, and the master output monitor is heard from the R-side.
STEREO
The sound of the channel whose channel [CUE] button is lit is mixed with the
master output, and output in stereo.
5
[CROSS FADER ASSIGN] switches
Specify the output destination of the channels.
A Output to cross fader A.
THRU Not assigned to the cross fader.
B Output to cross fader B.
6
[INPUT SELECT] switches
Select the input source for each channel.
CH1, CH2
PC
The sound loaded into the Serato DJ deck is the source.
Select this if you’re using DVS.
LINE The line level input is the source.
PHONO The phono level (MM type cartridge) input is the source.
CH3, CH4
PC
The sound loaded into the Serato DJ deck is the source.
Select this if you’re using DVS.
LINE The line level input is the source.
USB The input from the USB HOST port is the source.
7
[CROSS FADER] switch
Switches the response curve of the cross fader.
8
[CH FADER] switch
Switches the response curve of the channel faders.