User`s manual

Part 1
12
Depth regulator nose
This is adjusted when engraving a material
which does not have uniform thickness.
Cover
When opening the cover during operation, press the [ENTER/PAUSE]
key to pause operation.
Wait until operation stops completely, then open the cover. To resume
operation, close the cover and press the [ENTER/PAUSE] key again.
If you open the cover during operation without pressing the [ENTER/
PAUSE] key first, a single processing step is carried out, then operation
stops.
Parallel connector
A parallel (printer)
cable is connected here.
Serial connector
A serial (RS-232C)
cable is connected here.
Left side view
Head
This moves the spindle (cutter) up and down). The
head performs X-axis, Y-axis and Z-axis movement.
Scale (for Checking the Z-axis Cutting Range)
This can be used to confirm the cutting range of the
Z axis.
The cutting range of the Z axis is 30 mm (1-1/8 in.).
According to the scale, the cutting range is 5 to 35
(mm) when the depth-regulator nose is installed, and
0 to 30 (mm) when not installed.
Cutter holder
This is where the cutter
is mounted.
1-2 Part Names and Functions
Table
The table grips the workpiece to be cut.
Described on the
following page
External output
connector
Right side view
Power switch
Power connector
The power cord included
with the machine is con-
nected here.
Scale (for Checking the Z1 Position)
When using the depth-regulator nose,
this can be used to confirm the Z1
position that has been set.
Z adjust screw
Loosen the Z adjust screw if it
is necessary to adjust the depth
regulator nose for performing
engraving.
Depth regulator nose
Knurled
retainer nut
Micrometer dial