User`s manual

Part 1
20
To load workpiece, use the adhesive sheet or clamps included with the machine.
When performing engraving that subjects the workpiece to a load, use the clamps to secure the workpiece in place. When engraving the
edge of the workpiece, use the adhesive sheet.
Large-size material (i.e., material that is about the same size as the EGX-300's table) cannot be affixed to the table securely using the
adhesive sheet or clamps. In such cases, use commercially available double-sided tape to secure the workpiece in place.
Loading Workpiece Using the Adhesive Sheet
Place the adhesive sheet on the table and press it
down.
1
Place the workpiece to be cut on the adhesive sheet
and fasten it while pressing down.
2
Adhesive
sheet
Adhesive
sheet
Workpiece
Store the adhesive sheet in a location free from dust.
Loading Workpiece Using the Clamps
Place the workpiece on the table.
1
Slide the square portion protruding from the bottom
of the clamp plate into the groove on the table to
secure the workpiece in place.
2
Workpiece
Tighten
1-6 Loading a Workpiece for Cutting
Fasten the tool and material securely in place.
NOTICE
A vacuum table (ZV-23A) and a center vise (ZV-23C) are optionally available and should be purchased if needed.
Do not attempt to wash the adhesive sheet with water. Doing so will damage the adhesive surface and make it
impossible to grip the material.
NOTICE
Groove
Wrenches
(10 mm end
of the wrench)
Workpiece
Clamp