User`s manual

Part 2
39
Canceling the Paused State to Resume Cutting
After changing the feed rate, cancel the paused state. Cutting then resumes at the new feed rate or spindle speed.
Press the [MENU] key to make the following screen
appear on the display.
1
Press the [ ] key to move the blinking cursor (“ ”) to
“CONTINUE,” and then press the [ENTER] key.
2
In the case that you begin cutting and then find that you have sent the wrong cutting data, perform the following operation.
Stopping the Cutting Process
Press the [ENTER/PAUSE] key while cutting is in
progress. One cutting step is performed, after which
operation stops. The display changes to show the
following message.
1
Use the software to stop data output.
2
Press the [ ] key to move the blinking cursor (“ ”) to
“STOP,” and then press the [ENTER] key.
3