User`s manual

Part 2
47
Is the cover open?
Is operation paused?
Do the EGX-300's connection parameter settings
match the settings for the computer?
Is the power for the EGX-300 switched on?
Has the connection cable come loose?
Is the correct connection cable being used?
Is the correct output device setting (or driver
selection) made for the application software?
The EGX-300 will not operate when the cover is open. Close the cover
and try again.
If the [ENTER/PAUSE] key is pressed while the machine is in operation,
the message “Pause On” appears on the display and operation is paused.
Choose “CONTINUE” and press the [ENTER/PAUSE] key again to
cancel the paused state.
Refer to “Setting the Connection Parameters” to make the correct settings.
Make sure the EGX-300 is powered up.
Make sure the connection cable is plugged in securely with no looseness
at either end.
The type of connection cable varies according to the computer being used.
Also, some application software requires the use of a special cable. Make
sure the correct cable is being used.
Refer to the documentation for the application software to make the
correct output device setting (or driver selection) for the application
software.
When the EGX-300 does not work...
Is “REVOLUTION” set to “OFF?” If “REVOLUTION” is set to “OFF,” the spindle will cut without
rotating.
Change the setting for “REVOLUTION” to “ON.”
When the spindle does not rotate ...
The power does not come on...
Is the EMERGENCY STOP switch set to STOP
(
)?
Has the power cord come loose?
If the EMERGENCY STOP switch has been depressed, the power will not
come on when the power switch is turned on.
Set the EMERGENCY STOP switch to RELEASE (
).
Make sure the power cord is plugged in securely with no looseness at
either end.
Cutting depth varies in places (deep and shallow cuts)
Is the workpiece flexing?
Is the workpiece height uneven because of the
double-sided tape used for securing it was stuck
on poorly?
Check the setting and clamping of the workpiece.
Check how well the material is secured and reload it.
* Cutting to the same depth, even of workpieces of different thicknesses can be done if the depth regulator nose is used.
2-5 Troubleshooting