User`s manual

3 Replacement of Main Parts

When the Pressing Force matches with the Bending

Amount, tighten up the Screw1 and Screw2. Then, carry out

the X Axis Load check.

If the Pressing Force does not match with the Bending

Amount, adjust the Belt Tension by Nut1 and 2 again. After

that, measure the tension and when the Belt Tension

becomes to the proper value, tighten up the Nut1 and 2.

Pressing Force Bending Amount

EGX-600 720gf 10.0mm

EGX-400 720gf 7.0mm

Nut2

Screw2

Nut1

Frame

Screw1

Turn on the Power while pressing the [ ], [ ], [ ]

keys to enter the Service Mode.

Select the [LOAD] menu by pressing the [MENU] key and

press [ENTER] key.

CHECK MODE

LOAD CON. CARD

[ ], [ ], [ ] + POWER ON

[ENTER] key

[MENU] key

Push the X-Belt with the Tension Gauge (ST-001) at the

center position of the X Belt and check the bending amount

with the ruler.

Confirm that the Pressing Force matches with the Bending

Amount in reference to the next table.

X Belt

ST-001