Recorder Owner's Manual

Recording

• To ensure that the comments of all participants are

recorded consistently, place the R-05 in the center

of the table. Set the [MIC GAIN] switch to H if you’re

recording sounds that are at a typical

conversational level.

• If you turn AGC on, the level will be automatically

adjusted according to the loudness of the speaker’s

voice, ensuring that the recording will be consistent

even for people with a softer voice or who are at a

distance. However, turning on AGC (p. 48) will also

boost faint low-frequency background sounds such

as an operating air conditioner, capturing these

unwanted sounds as well. If so, turn [LOW CUT] on

to reduce the unwanted low-frequency noise while

capturing the voices more clearly.

• Since the purpose is to create a record of the

comments by each participant, the audio quality

of the recording is not of primary importance.

Choose MP3 as the recording mode to keep the

file size small even for an extended recording.

Recommended settings

Recording a Meeting

Rear panel switches

MIC GAIN H

LIMITER ON

LOW CUT ON

“Menu” screen settings

Recorder

Setup

Sampling Rate 44.1kHz

Rec Mode MP3-128 kbps or lower

Limiter/AGC AGC

Input

Setup

Low cut filter

cutoff

200Hz

R-05-e.book 62 ページ２０１０年２月１９日　金曜日　午後４時５５分