User`s manual

2 Basic Operation

2-4 Test Printing

Before starting to print, carry out a Test print to check the state of the head.

Problems such as missing dots may reduce the printing quality.

If the test results show a problem, carry out head cleaning to restore the head to its normal state.

Load a material, then close the front cover.

Press the [CLEANING] key to execute [TEST PRINT].

If there are any missing dots or other evidence

of a drop in printing quality, clean the head.

For more information about head cleaning, see

"3-3 Cleaning the Printing Heads."

If there is dot drop-out in both areas, then for

[CLEANING], choose [BOTH HEADS].

Direction of material

discharge

If there is dot drop-out on this side,

then for [CLEANING], choose

[RIGHT HEAD].

If there is dot drop-out on

this side, then for

[CLEANING], choose

[LEFT HEAD].

CLEANING

TEST PRINT

Press the [ENTER] key to

print a test pattern.