User`s manual

81
4 User's Reference
For Macintosh
In the included "Roland-PrintServer for Macintosh Users,"
follow the instructions in "Setting the IP Address for the Print
Server and Verifying the Network Connection" and verify the
settings.
For Windows NT 4.0
Click [Start].
Point to [Programs], then click [Command Prompt].
Run [ping <IP address>].
When the print server responds correctly, the results are like
those shown in the figure.
When the print server does not respond correctly, the results are
like those shown in the figure.
Investigate and eliminate the cause, so that the correct response
is obtained.
If there is no response from the print server and the results are as
shown in the figure, one of the following may be the cause.
- The printer is not turned on.
- The network device is not turned on.
- The network cables are not connected correctly.
- The IP address was entered incorrectly.
If an error message is returned from the gateway and the results
are like those at right, one of the following may be the cause.
- The IP address was entered incorrectly.
- The settings for the gateway are not correct.
Aside from these, the information displayed may change,
depending on the error.