Owner's Manual Digital Piano FP-2
Table Of Contents
- USING THE UNIT SAFELY
- IMPORTANT NOTES
- Contents
- Panel Descriptions
- Before You Play
- Chapter 1 Playing the Keyboard
- Listening to Demo Songs
- Listening to Internal Songs
- Performing with a Variety of Sounds
- Performing With Two Layered Tones (Dual Play)
- Performing With Different Tones in the Left and Right Sides of the Keyboard (Split Play)
- Changing the Volume Balance for Dual Play and Split Play
- Changing the Keyboard’s Touch
- Adding Reverberation to Sounds (The Reverb Effect)
- Adding a Variety Effects to the Sound
- Transposing the Key of the Keyboard (Key Transpose)
- Using the Metronome
- Boosting the Low-Frequency Range (Sound Control)
- Changing the Tonal Quality (Equalizer)
- Chapter 2 Playing Along with Rhythms
- What is Session Partner?
- Performing Along With Session Partner
- Selecting a Rhythm
- Changing a Rhythm’s Tempo
- Selecting a Rhythm’s Chord Progression
- Performing With the Chord Progression Specified in the Left Hand (Chord Progression off)
- Recording the Chord Progression (Chord Progression)
- Storing Settings (Setup)
- Chapter 3 Recording a Performance
- Chapter 4 Other Functions
- How to Make Settings
- Changing How the Pedal Effects Are Applied
- Changing How the Pedals Work
- Changing the Effect Type
- Setting the Part to Which Effects Are Added
- Changing the Pitch of the Lower Tone in Octave Steps (Octave Shift)
- Tuning to Other Instruments’ Pitches (Master Tuning)
- Adjusting the Tuning (Temperament)
- Changing the Beat of Metronome
- Setting the Intro and Ending On or Off
- Fixing a Set Chord Progression
- Setting the Root Note of the Chord Progression
- Setting the Chord Display On or Off
- Changing the Equalizer Settings
- Connecting to Audio Equipment
- About the FP-2 Sound Generator
- Connecting to the USB Connector
- Connecting MIDI Devices
- Using the V-LINK function
- Making the Settings for the USB Driver
- Restoring the Settings to the Factory Condition (Factory Reset)
- Disabling Everything Except Piano Play (Panel Lock)
- Troubleshooting
- Error Messages/Other Messages
- Tone List
- Rhythm List
- Chord Progression Pattern List
- Chord Fingering List
- Internal Song List
- Settings Stored in the Setup
- Easy Operation List
- MIDI Implementation Chart
- Main Specifications
- Index
17
Chapter 1 Playing the Keyboard
■
Changing Tone Group and Tone Variation.
Changing the Upper Tone
1.
Press the Tone button to choose a Tone Group.
2.
Press the [-] or [+] buttons to select the Tones.
Changing the Lower Tone
1.
Hold down the [Split] button and press the Tone button to
choose a Tone Group.
2.
Hold down the [Split] button and press the [-] or [+] buttons
to select a Tones.
For more on selecting tones, refer to “Performing with a Variety of Sounds”
(p. 14).
When the tone of the same
Tone button is selected for
both the Upper and Lower
Tones, the indicator for
Tone button flash in green
while the [Split] button is
held down.
Press
While holding down...
Press
You can change the pitch of
the Lower Tone an octave at
a time. Refer to “Changing
the Pitch of the Lower Tone
in Octave Steps (Octave
Shift)” (p. 41).
FP-2_e.book 17 ページ ２００４年１１月２６日 金曜日 午後４時２５分