Owner`s manual

6
About Operating Screens
Channel Strip Screen
Right after starting the M-480 Remote, you can see the Channel Strip screen as below.
g.channel-strip.eps
1
2 3
1 Overview Section
This section displays level meters of in/out channels and mute on/of statuses. Tapping a group of meters will switch the display of the
Channel Parameter section.
• CH 1 – 8, 9 – 16, 17 – 24, 25 – 32, 33 – 40, 41 - 48
• AUX 1 – 8, 9 - 16
• MTX 1 - 8
• RTN 1L - 4R, 5L - 6R
• MAIN LCR
2 Channel Parameter Section
You can change various settings of the displayed channel. For details, refer to About Channel Parameter Section on the next page.
3 Side Panel
The following buttons are located on the side panel. You can switch the screen or call up various functions using these buttons.
• ONLINE ONLINE screen (p. 4) that is used for connection of your iPad and the M-480.
• SCENE Call up the Scene List (p. 13).
• SYSTEM Change the touch response of knobs and faders (see below).
• SOLO CLEAR Clear the solo using this button. If solo of any channel is turned on, this button lights up.
• FUNCTION This calls up various functions (p. 15).
• GEQ Tap this button to switch to the GEQ setup screen.
• SENDS ON FADER Tap this button to switch to Sends on Fader mode (p. 14). You can see the target bus on the popup.
SYSTEM : Changing the touch response
Tap the SYSTEM button to open the screen below. Move the slider with left/right drag operation to adjust the reaction time. The reaction
time determines how long a fader or knob has to be held before it reacts to motion. This helps avoid inadvertent changes due to a casual
touch. Reaction time can be set between 0 and 0.5 seconds.
g.reaction-time.eps