Setup guide

Chapter 3 Printing

3-1 Print Job Setting

Printing with White Ink and CMYKLcLm Ink (W Mode)

This section describes how to perform printing with the white ink and CMYKLcLm ink when the printer is in W

mode (7 colors of CMYKLcLmW). Deciding which ink between the white and the CMYKLcLm you want to use

for the base is an important point in determining the print job setting here. To use the white ink for printing,

you need to use the printing data where the use of the white ink is designated.

 P. 12, “2-3 Creating Printing Data”

Procedure



Make sure that you have nished making the preparations for VersaWorks, getting the

printer ready, and creating the printing data ( page 9, "Chapter 2 -- Getting Ready").



Double-click .

Queue A Properties" window appears.



Click .

For [Media Type], select “xxx: Clear PET

Film” or “xxx: PET Clear Film, Adhesive.”

“xxx” indicates “ESP-CL” and others.

For [Print Quality], select [High Quality].

Do not select [High Speed]. Printing can not be

performed with white and CMYKLcLm.

With [Mode], select the print mode.

White -> CMYKLcLm (v)

Inks are overprinted in the sequence of white and

then CMYKLcLm Color.

CMYKLcLm -> White (v)

Inks are overprinted in the sequence of CMYKLcLm

and then white Color.

* The image of overprinting in the sequence of white and CMYKLcLm is the same as that of overprinting in

the sequence of white and metallic silver/CMYK on page 35. (The description of “metallic silver/CMYK” is

to be replaced with “CMYKLcLm” only.)