User Manual

7
Panel Descriptions
Rear Panel
(Connecting Your Equipment)
* To prevent malfunction and equipment failure, always turn down the volume, and turn o all the units before making any connections.
A
DC IN jack
Connect the included AC adaptor to this jack.
* Use the cord hook to secure the cord of the AC adaptor as shown in the
illustration.
B
[POWER] switch
Turns the power on/o.
C
USB (O) port
Use a commercially available USB 2.0 cable (type B) to connect this
port to your computer or smartphone. This is used to transfer USB
MIDI and USB audio data.
* A USB driver is not required when connecting to this unit.
* This unit also supports USB bus power. The following functions are limited
when the unit operates via USB bus power.
5 Phantom power cannot be used.
5 The headphone volume is lowered.
5 The LEDs are dimmer.
To use USB bus power without limiting functionality, hold down the [VALUE]
dial while powering up this unit. Note that this unit may not start up,
depending on the amount of USB bus power supplied.
D
MIDI connectors
Connect these to an external MIDI device to transmit and receive
MIDI messages.
E
SD card slot
Insert an SD card here. The SD card contains various data (such as
projects, settings, tones and samples) for this unit.
* You can install the included SD card protector to prevent the SD card from
being accidentally pulled out. Use the two included screws to fasten the
card protector in place.
* Never turn o the power or remove the SD card while the SD card is being
accessed.
* Some SD card types or SD cards from some manufacturers may not record
or play back properly on the unit.
F
LINE IN jacks
These are the audio input jacks. Connect your musical instrument
or other equipment to these jacks.
G
MIC connector
Connect your dynamic mic or condenser mic to this connector.
* Pin assignment of MIC connector
1: GND
2: HOT
TIP: HOT
RING: COLD
SLEEVE: GND
3: COLD
2: HOT
1: GND
3: COLD
* About phantom power
You can supply phantom power (+48 V) from the MIC connector. Turn on
phantom power when you’re using a condenser microphone that requires
phantom power.
Use the [INPUT] button0set “Phantom Sw” to “ON.”
NOTE
5 If you don’t need phantom power, be sure to turn phantom power o. You
risk causing damage if you mistakenly supply phantom power to dynamic
microphones or other devices that don’t require such power.
5 Phantom power cannot be used when this unit operates on USB bus power.
H
LINE OUT jacks
These are jacks for outputting the audio signal. Connect these to
your amp or monitor speakers.
Turning the Power On/O
* Before turning the unit on/o, always be sure to turn the volume down. Even
with the volume turned down, you might hear some sound when switching
the unit on/o. However, this is normal and does not indicate a malfunction.
Turning the power on
1. Power-on your equipment in the order of this unit 0
connected equipment.
2. Raise the volume to an appropriate level.
Turning O the Power
1. Power-o your equipment in the order of connected
equipment 0this unit.
Cord hook
AC adaptor
A
B
F
E D
C
G
H