Specifications
Table Of Contents
- Contents
- Chapter 1 Introduction
- Chapter 2 Operation
- Chapter 3 Maintenance and Adjustment
- Chapter 4 Feature Reference
- 4-1 Pausing or Canceling Output
- 4-2 Setting the Location for Starting Output
- 4-3 Saving the Printer Settings to Match the Media
- 4-4 Optimizing Printing or Cutting to Match Media Thickness
- Adjusting Head Height to Match Media Thickness (54-inch Model Only)
- Correcting for Misalignment in Bidirectional Printing
- Correcting for Misalignment in Bidirectional Printing More Precisely
- Performing Feed Correction to Alleviate Horizontal Bands and the Like
- Performing Distance Correction During Cutting
- 4-5 Accommodating Various Kinds of Media
- 4-6 Changing How the Printer Operates
- 4-7 Changing the Ink-drying Method
- 4-8 Making Various Adjustments for Cutting
- 4-9 Performing Printing and Cutting Separately
- 4-10 Making the Network Settings
- 4-11 Viewing Information about the Media and the System
- 4-12 Performing Maintenance
- 4-13 Menu List
- Chapter 5 What to Do If
- Chapter 6 Specifications
4-9 Performing Printing and Cutting Separately
99
4
Feature
Reference
2.
Execute the [ADJUST BI-DIR] menu item.
Load the media.
P. 32, "Loading Media," p. 82, "How to Load Sheet Media"
Perform bidirectional adjustment.
P. 73, "Correcting for Misalignment in Bidirectional Printing," p. 74, "Correcting for Misalignment in Bidirectional Printing More
Precisely"
3.
Print a test pattern and cut it.
Press .
Press
.
Press .
Press
.
Press .
Press
.
When adjustment is needed, go on to the steps below.
4.
Print and cut a test pattern for adjustment.
Press .
Press
to execute.
5.
From the test pattern, read the correction value at the location.
MENU
CUTTING MENU
CUTTING MENU
CROP - CUT ADJ.
CROP - CUT ADJ.
TEST PRINT
CROP - CUT ADJ.
TEST PRINT 2
Printing
position
Cutting
position
Cutting position and printing
position are misaligned.
Cutting position and printing
position are aligned.
Printing
position
Cutting
position
Test pattern
Check the value on
the [SCAN] side.
Correction-value scale
Check the value on
the [FEED] side.
Cutting line
The point where the cutting line
intersects the correction-value scale is
the correction value. In this gure, the
value is "-0.3." Use the same method
to read the value on the [FEED] side.
Cutting line
Scan direction