Specifications
Table Of Contents
- Contents
- Chapter 1 Introduction
- Chapter 2 Operation
- Chapter 3 Maintenance and Adjustment
- Chapter 4 Feature Reference
- 4-1 Pausing or Canceling Output
- 4-2 Setting the Location for Starting Output
- 4-3 Saving the Printer Settings to Match the Media
- 4-4 Optimizing Printing or Cutting to Match Media Thickness
- Adjusting Head Height to Match Media Thickness (54-inch Model Only)
- Correcting for Misalignment in Bidirectional Printing
- Correcting for Misalignment in Bidirectional Printing More Precisely
- Performing Feed Correction to Alleviate Horizontal Bands and the Like
- Performing Distance Correction During Cutting
- 4-5 Accommodating Various Kinds of Media
- 4-6 Changing How the Printer Operates
- 4-7 Changing the Ink-drying Method
- 4-8 Making Various Adjustments for Cutting
- 4-9 Performing Printing and Cutting Separately
- 4-10 Making the Network Settings
- 4-11 Viewing Information about the Media and the System
- 4-12 Performing Maintenance
- 4-13 Menu List
- Chapter 5 What to Do If
- Chapter 6 Specifications
41
2
Operation
2-4 Starting Output
Getting Ready to Receive Data from a Computer
When you have nished loading media and making the temperature settings for the media heating system, then follow the
steps below. This procedure enables the machine to receive data from the computer and perform output. When printing
data that includes cutting paths is received, you can also carry out cutting immediately after performing printing.
Note, however, that when you want to perform only cutting, operation that differs from the following pro-
cedure is required.
P. 45, "To Perform Cutting"
CAUTION
Never touch the print heads while output is in progress.
The print heads move at high speed. Contact may cause injury.
Procedure
Close the front cover.
Make sure stays steadily lit.
If the light does not come on, lower the loading lever.
Wait until stops ashing and stays steadily lit.
Make sure the top menu is displayed.
If the top menu is not displayed, press
, then press .
Output Is Not Possible in These Situations
The machine does not run when the front cover is open. Also, never open it when printing is in progress.
Doing so interrupts printing.
Data from the computer is not accepted when is dark.
Printing does not start until lights up.
Data from the computer is not accepted when you are not at the top menu.
Points Which Must Be Observed
Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and
catch on the print heads.
During output, never touch the media that's already been discharged. Doing so may obstruct media
feed or cause the media to rub against the heads, which may result in a paper jam or damage to the
heads.
Top menu
Steadily lighted
Flashing
Steadily lighted