User`s manual

22
Chapter 2 - Basic Operation
2
When cutting is performed after printing, the cap tip of the blade holder may scratch the printed surface.
If this is the case, lengthen the cutter blade extension.
Removing a Blade
1
1) Loosen
2) Remove the blade holder from
the cutting carriage.
Press the pin and remove
the blade from the blade
holder.
Blade
Blade holder
Cutting carriage
Tool-securing screw
Leave the tool-securing screw loose. Tightening
the screw makes it more difficult to install the
blade holder.
If a blade was used, wipe the blade with a soft
cloth to remove any material that may cling to it.
Pin