User`s manual

50
Chapter 3 - User's Reference
If the Blade Becomes Dull
When the blade starts to lose its sharpness, try gradually increasing the cutter force.
Increasing the cutter force temporarily allows the blade to perform better. However, once the blade is dull, it is time to replace it.
Average Blade Life
The life of a blade varies, depending on the amount of cutting it performs.
The total cutting length can vary considerably, depending on the thickness, toughness, and type of adhesive of the cut material. Set an
appropriate cutter force, one that is well matched to the material and the hardness of the blade. This will extend the life of the blade.
Excessive cutter forces can cause the blade to wear out quickly. Care should be taken.
The table below provides a rough guide to appropriate cutting conditions and expected blade life.
Please note that making the settings for conditions shown below will not necessarily achieve attractive cutting results in all circum-
stances. Before performing actual cutting, please carry out a cutting test and adjust as required (see "6 Cut Test & Self-test").
3-6 About the Blade
Blade Material Pen-force scale Speed Blade compensation Life of a blade
ZEC-U1005 General Signal Vinyl 30 cm/sec. 0.25 mm 8000 m
(11.811 in./sec.) (0.00984 in.) (314960 in.)
ZEC-U5025 General Signal Vinyl 30 cm/sec. 0.25 mm 4000 m
(11.811 in./sec.) (0.00984 in.) (157480 in.)