Owner`s manual

19
Getting Connected and Installing Drivers (Windows)
5
Click [OK] to close the System Properties dialog box.
6
Exit all currently running software (applications).
Also close any open windows. If you are using virus checking or similar
software, be sure to exit it as well.
7
Prepare the CD-ROM.
Insert the CD-ROM into the CD-ROM drive of your computer.
8
Click the Windows start menu. From the menu that appears, select “Run...”
The “Run...” dialog box will appear.
fig.2-3_30
9
Specify the name of the file you want
to execute.
Enter the following into the “Open”
field, and click [OK] .
(drive name) : \Driver\USB_XP2K\SETUPINF.EXE
The SetupInf dialog box will appear.
You are now ready to install the driver.
* In the explanatory example shown here, the drive name is given as “D:” . The drive
name “D:” may be different for your system. Specify the drive name of your CD-
ROM drive.
10
Use the USB cable to connect the PCR to your computer.
1. Set the PCR’s power switch to the “OFF” position.
2. Use the USB cable to connect the PCR to your computer.
3. Set the PCR’s power switch to the “USB” position.
Near the task bar, your computer will indicate “Found New Hardware” .
Please wait.
11
The Found New Hardware Wizard will appear.
Select “Install from a list or specific location (Advanced)” , and click
[Next] .
If the screen indicates
“Windows can perform
the same action each
time you insert a disk or
connect a device with
this kind of file”, click
[Cancel].
To check the drive name
Click the Start menu, and
choose My Computer from
the menu that appears. In
the window that appears,
check the drive name of
the CD-ROM drive into
which you inserted the
CD-ROM in step 7.
The drive name is the (D:)
or (E:) displayed by the
CD-ROM drive .
Once the connections have
b
een completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.
If the Found New
Hardware Wizard asks
you whether you want to
connect to Windows
Update, choose “No” and
then click [Next].
PCR-M1_e.book 19 ページ ２００７年２月５日 月曜日 午前１１時１９分