Owner`s manual

33
Getting Connected and Installing Drivers (Macintosh)
■ Software settings
1
Use the USB cable to connect the PCR to your computer.
1. Set the PCR’s power switch to the “OFF” position.
2. Use the USB cable to connect the PCR to your computer.
3. Set the PCR’s power switch to the “USB” position.
* Connect the cable to the USB connector of the Macintosh itself, not to the USB
connector of the keyboard.
2
Make MIDI device settings on your sequencer software.
For details on the PCR’s input/output devices, refer to Input / output
devices (p. 45).
Once the connections have
b
een completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.
For details on MIDI device
settings, refer to the
owner’s manual for the
software you are using.
When using the PCR with your software
Before using the PCR with your software, please note the following points.
• Use the USB cable to connect the PCR to your computer before you start up your software.
• Do not disconnect the USB cable from the PCR while your software is running.
• Quit your software before you disconnect the USB cable from the PCR.
• Turn off the Sleep function of your Macintosh.
• The PCR will not operate in the Mac OS X Classic environment. Use the PCR when the Classic
environment is not running.
PCR-M1_e.book 33 ページ ２００７年２月５日 月曜日 午前１１時１９分