Owner`s manual

35
Getting Connected and Installing Drivers (Macintosh)
■ Setting the driver
If you are using FreeMIDI, proceed to FreeMIDI settings (p. 38).
OMS settings
1
Use the USB cable to connect the PCR to your computer.
1. Set the PCR’s power switch to the “OFF” position.
2. Use the USB cable to connect the PCR to your computer.
3. Set the PCR’s power switch to the “USB” position.
* Connect the cable to the USB connector of the Macintosh itself, not to the USB
connector of the keyboard.
fig.3-3
2
From the CD-ROM, drag the Driver E (Mac OS 9) - OMS
Setting folder into the Opcode - OMS Applications
folder on the hard disk of your Macintosh to copy it there.
fig.3-4
3
In the Opcode - OMS Applications folder where you
installed OMS, double-click OMS Setup to start it up.
fig.3-5_35
4
If a dialog box like the one shown
here appears, click [Turn It Off] . A
confirmation dialog box will then
appear, so click [OK] .
fig.3-6_35
5
The Create a New Studio Setup
dialog box will appear. Click
[Cancel] .
If you accidentally clicked [OK] ,
click [Cancel] in the next screen.
Once the connections have
b
een completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
b
efore the unit will operate
normally.
If you are using the PCR in
conjunction with other
MIDI devices, make
settings as described in
Readme_E.htm located in
the Driver E (Mac OS 9)
folder of the CD-ROM.
We recommend that you
turn off AppleTalk, by
selecting Chooser from the
Apple menu.
PCR-M1_e.book 35 ページ ２００７年２月５日 月曜日 午前１１時１９分