Owner`s manual

42
Basic connections and MIDI flow
USB connections with your computer
– Sending MIDI messages to your application –
fig.connect-basic
* To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and
turn off the power on all devices before making any connections.
*
Use only the specified expression pedal (EV Series; sold separately). By connecting any other expression
pedals, you risk causing malfunction and/or damage to the unit.
■ MIDI flow
Turn MIDI I/F MODE OFF as described in “MIDI I/F MODE” (
p. 94).
fig.flow-usb
* For an explanation of the items in the diagram, refer to Input / output devices (p. 45).
* For more about BULK data, refer to “ Bulk dump ” (p. 87).
BULK RECEPTION BULK data is received here
PORT 1
Of the keyboard, pitch bender, and other controllers, those that have been set to PORT 1 will transmit data
from here
PORT 2
Of the keyboard, pitch bender, and other controllers, those that have been set to PORT 2 will transmit data
from here
BULK TRANSMISSION BULK data is transmitted from here
DP series
(sold separately)
AC adaptor (sold separately)
It is not necessary to connect the AC
adaptor if you are using a USB
connection. However, with some
computers, the PCR-1M may not
operate when powered from the USB
bus. In this case, set the power switch to
the DC position and connect the AC
adaptor.
EV series
(sold separately)
USB cable
MIDI OUT
MIDI IN
PCR-M1PC
USB
EDIROL PCR
EDIROL PCR MIDI OUT
EDIROL PCR 2
EDIROL PCR 1
PORT 1
EDIROL PCR MIDI IN
MIDI I/F MODE OFF
PORT 2 /
BULK RECEPTION
MIDI OUT DEVICE
MIDI IN DEVICE
BULK TRANSMISSION
PCR-M1_e.book 42 ページ ２００７年２月５日 月曜日 午前１１時１９分