Owner`s manual

Use MIDI functionality

OMNI

If you turn the Omni setting ON, all messages will be transmitted on the current channel

regardless of the channel that is specified for each controller.

Also, all messages will be transmitted to the KEYBOARD PORT SET (p. 93) regardless of the

port that is specified for each controller.

fig.edt

1. Press the [EDIT] button.

The display will indicate “EDT”.

fig.omn

2. Press the [OMNI] key.

The display will blink “OMN”.

3. Confirm what’s indicated and press the [ENTER] button.

4. The display will show the current setting.

5. Use the [VALUE] dial, the [DEC] [INC] buttons, or the [0] or [1] keys to select the mode.

6. Press the [ENTER] button.

0 OMNI OFF

Messages will be transmitted on the channel and port specified

for each controller.

1 OMNI ON

Messages will be transmitted on the current channel from the

Keyboard Port, regardless of the channel and port specified for

each controller.

Setting the input mode

fig.hexdec

If you are not in Play mode, you can use one of two ways to input a numerical

value into the PCR-M1; Decimal input mode or Hexadecimal input mode.

If you want to input decimal numbers, press the [DECIMAL] button. If you

want to input hexadecimal numbers, press the [HEX] button. When you turn

on the power, the PCR-M1 will start up in Decimal mode.

Decimal and hexadecimal numbers correspond as follows.

Decimal:0–127

Hexadecimal:00–7F

However, for MIDI CH and PROGRAM CHANGE, the values are as follows.

* Normally, the display will show three digits when using Decimal input mode. For this reason, there will

be no indication of the parameter you are now inputting, and you may lose track of what you are doing.

If this occurs, you can temporarily switch back to Hexadecimal mode to check the parameter you are

inputting. Then switch back to Decimal mode and continue.

Decimal Hexadecimal

MIDI CH 1–16 00–0F

PROGRAM CHANGE 1–128 00-7F

PCR-M1_e.book 51 ページ２００７年２月５日　月曜日　午前１１時１９分