Owner`s manual

62
Use MIDI functionality
AFTERTOUCH ASSIGN
Here’s how to assign an Aftertouch message to a controller.
● Basic mode
fig.edt2
1
Press the [EDIT] button.
The display will indicate “EDT.”
fig.r-1
2
Slightly move the controller to which you want to assign an Aftertouch
message. In the case of a button, press that button.
The display will indicate the number of the selected controller.
3
Verify that the display shows the correct controller number, and press the [ENTER] button.
fig.at1
4
Press an ASSIGNABLE FUNCTION key ( ) on the keyboard enough times
to get “AT0” to appear in the display.
fig.c
5
Verify that the display is correct, and press the [ENTER] button.
The display will indicate “C–”.
6
Input the channel. Use the [VALUE] dial, the [DEC] [INC] buttons, or the [0] - [F] keys to
specify the channel.
7
Press the [ENTER] button.
8
If you are making an assignment for a button, specify the button mode.
( ➝ Specifying the button mode (p. 59))
Mode Keyboard Message Value range Port
Basic mode 0 Channel Pressure 0-127 (00–7FH) Port 1
Advanced mode 1 1 Channel Pressure Upper and
lower limits
are assignable
Assignable
Advanced mode 2 2 Polyphonic Key Pressure 0-127 (00–7FH) Port 1
Advanced mode 3 3 Polyphonic Key Pressure Upper and
lower limits
are assignable
Assignable
*1 Reference
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.
PCR-M1_e.book 62 ページ ２００７年２月５日 月曜日 午前１１時１９分