Owner`s manual

93
System settings
KEYBOARD PORT SET (Keyboard: 4)
Perform steps 1-3.
4. Use the [VALUE] dial, the [DEC] [INC] buttons or the [1] - [3] keys to specify KEYBOARD
PORT SET. ( ➝ Specifying the port (p. 59))
The specified port will indicate in the display.
5. Press the [ENTER] button.
H-ACTIVITY ON / OFF (Keyboard: 5)
fig.hyo
Perform steps 1-3.
4. Use the [VALUE] dial, the [DEC] [INC] buttons or the [0] or [1] keys to
switch H-ACTIVITY ON / OFF.
The display will indicate either “ON” or “OFF”.
5. Press the [ENTER] button.
USB MIDI DRIVER MODE (Keyboard: 6)
Perform steps 1-3.
4. Use the [VALUE] dial, the [DEC] [INC] buttons or the [0] or [1] keys to specify the USB
MIDI DRIVER MODE.
* FPT = Fast Processing Technology for MIDI Transmission:
Effective use is made of the USB bandwidth according to the amount of MIDI data to be transmitted,
ensuring that MIDI data processing will always occur optimally.
5. Press the [ENTER] button.
STARTUP MEMORY (Keyboard: 7)
Perform steps 1–3.
4. Use the [VALUE] dial, the [DEC] [INC] buttons or the [0] or [1] keys to specify the GM2/
LAST ACCESS MEMORY setting.
5. Press the [ENTER] button.
0 Original driver
FPT technology is used to perform high-speed MIDI trans-
fer. Normally, we recommend that you use this mode.
1 Generic driver
Select this if you are using the standard MIDI driver provid-
ed by your operating system.
0 GM2 MEMORY
When the PCR starts up, memory number 0 (GM2) will
be loaded into current memory (p. 86) regardless of the
state in which the power was turned off.
1
LAST ACCESS
MEMORY
Upon power-up, the PCR-M1 will recall the memory
that was last recalled or saved into current memory (p.
86).
0 OFF
1 ON
PCR-M1_e.book 93 ページ ２００７年２月５日 月曜日 午前１１時１９分