Owner`s manual

Head Adjustment

The head tension of the KD-120 can be adjusted.

Adjusting the Head Tension

When adjusting, use the included drum key or the drum key for your acoustic drums.

In general, a tension that produces a strike response approximately the same as an

acoustic bass drum will be appropriate.

* Head tension that is too loose may not only cause incorrect operation, but may even damage the

sensor.

fig.14.e

Check the current tension of the head.

Remove the kick pedal from the KD-120.

Adjust bolt ‘a’ in the above diagram. Rotate it clockwise to tighten the head tension, or

slightly counterclockwise to loosen the tension.

* Fully tightening a tuning bolt at only a single location produces uneven tensioning, which may

make it impossible to obtain the proper strike sensitivity and may even result in incorrect

operation. Be sure to tighten each tuning bolt a little at a time, as described in the above

explanation.

Adjust bolt ‘b’ so that the tension is the same as the tension of ‘a’.

Next adjust ‘c’ and ‘d’, and ‘e’ and ‘f’ in the same way.

Make sure that the head tension is even, and repeat steps 5 and 6 if you wish to make

further adjustments.

* On the KD-120, adjusting the head tension affects only the head response, and does not change

the pitch of the sound as it would on an acoustic drum. To adjust the pitch, edit the sound

parameters of the TD-20 or TD-12. For details refer to the respective owner’s manual.

* The head tension will change as the instrument is used, so you should readjust when necessary.

Mount the kick pedal on the KD-120.

HEAD MADE BY REMO U.S.A.

KD-120_e.book 8 ページ２００７年８月１日　水曜日　午前９時４９分