User Manual

4
Panel Descriptions
1 V-drums INPUT jack
Connect the drum sound module to this jack.
2 LINE INPUT jacks
Connect an audio player or electronic musical instrument here,
and hear it along with the drums.
Both stereo phone 1/4” and stereo mini 1/8” jacks are provided,
and can be used simultaneously.
Pin assignment of INPUT (V-Drums, LINE) jacks
Both mono and stereo are supported.
L
R
GND
SIGNAL
GND
GND
* This accepts 1/4” stereo phone plug. However, the speaker is
mono.
3 [V-Drums VOLUME] knob
Adjusts the volume of the device connected to the V-Drums
INPUT jack.
4 [LINE VOLUME] knob
Adjusts the volume of the device connected to the LINE INPUT
jacks.
5 [BASS] knob
Adjusts the level of the Low frequency.
6 [TREBLE] knob
Adjusts the level of the High frequency.
7 [POWER] switch/POWER indicator
This switch turns the power on/o.
When the power is on, the indicator will be lit.
Front Panel
1 2 3 4 5 6 7
Rear Panel
8
9
10
8 AC IN jack
Connect the included Power cord here. Plug it rmly in, so that the
cable does not accidentally become disconnected.
DIRECT OUT (PM-200 only)
9 DIRECT OUT L, R connectors
Connect this to your PA system or recorder.
The signals that are input to the INPUT jacks (V-Drums, LINE) are
output without change.
Pin assignment of DIRECT OUT connectors
1: GND 2: HOT
3: COLD
10 [DIRECT OUT] switch
When the signal that is input to the V-Drums INPUT jack is output
from the DIRECT OUT jacks, this switch selects whether the output
is stereo or mono.
* This switch does not aect the signal that is input to the LINE
INPUT jacks.
When the input is stereo When the input is mono
STEREO
Stereo output
Signal (mono) is output from
the L channel only
MONO
Same signal (mono) is output from the L and R channels