User`s manual

Part 1

7. Cutting Tool Attachment

Set the SPINDLE switch on the front of

the PNC-3100 to OFF.

• The LED lamp in the SPINDLE switch

flashes. (When power is applied.)

NOTICE

Use the correct tool for the material to be cut and the cutting method.

WARNING

When you attach the cutting tool, make sure that the SPINDLE switch is OFF.

LED

Spanners

Collet cap

If a cutting tool has been installed, remove

it. Use the two spanners provided to

loosen the collet cap.

• To keep the cutting tool from falling out,

loosen only slightly.

• After loosening, then loosen the cap by

hand and pull out the cutting tool.

Be careful to keep the cutting tool

from falling out, or the blade may

break.

CAUTION

The tool becomes hot when

metal is cut. Take care to avoid

burns.

NOTICE