User`s manual

Part 2
24
Operation Check
If the PNC-3100 operates abnormally, perform an operation check according to the instructions below. If, as a result
of the check, no abnormality is found, check for abnormalities in the computer, software or cable.
1
Turn the power ON. (If the power has
already been turned on, turn it off and then
back on again.
• The POWER/ERROR LED will light
up.
2
Press the Jog key.
• Move the XY table to the front, back, left
or right with the [
], [ ], [ ], [ ]
keys.
• Move the spindle up or down with the
[
(Z)
], [
(Z)
] jog keys.
3
Press the [VIEW] key for at least 0.5 sec-
onds.
• The spindle rises and the XY table moves
toward the front of the unit.
At least
0.5 seconds.
WARNING
Remove the tool, workpiece and vice before beginning the operation check.