Operation Manual

Panel Descriptions

4. PEAK indicator

Lights up when the input signal level is too high. Use the [SENS 1L] and [SENS 2R] knobs to adjust

the input level so that the PEAK indicator does not light.

5. [AUTO-SENS] button

Switches on/o the AUTO-SENS setting.

The AUTO-SENS setting allows you to optimize the input level by analyzing the input audio signal (p.

26).

6. USB indicator

Lights up when the QUAD-CAPTURE is connected to a computer and the computer has detected the

QUAD-CAPTURE.

7. [MONO] button

Switches the monitoring of the input signals arriving

at the INPUT 1L and INPUT 2R jacks between stereo

and monaural.

If you connect a guitar or bass to the INPUT 1L jack

and do not use the INPUT 2R jack, set this to monaural ([MONO] button lighted).

Even if this is set to monaural ([MONO] button lighted), the audio signal sent via USB to your

computer will be stereo.

8. [MIX] knob

Adjusts the monitor volume.

As you turn this knob to the left (towards

PLAYBACK), the levels of the audio signals

arriving at the various input jacks are

lowered. On the other hand, as you turn

this knob to the right (towards INPUT), the

output level of the audio signal output by

the computer is lowered. When positioned

at the center, the input levels of the audio

signal output by the computer and the

levels of the audio signals arriving at the

various input jacks will all be at 100%.

9. [OUTPUT] knob

Adjusts the volume of the audio signals output from the PHONES jack, OUTPUT 1L jack, and OUTPUT

2R jack.

10. PHONES jack

Used to connect headphones. This jack will output the same signal as the OUTPUT 1L and OUTPUT

2R jacks. Even if headphones are connected, sound will be output from the OUTPUT 1L and OUTPUT

2R jacks.

[MONO] button Monitored sound

Extinguished Stereo

Lit Monaural

PLAYBACK

INPUT

100%

Volume