Manualshelf

Owner`s manual

ManualsBrandsRoland Manualsaudio & home theatreQuad-Capture
51525354555657585960
51
Troubleshooting
Advanced Driver Settings
You can set the input and output audio buer size and ASIO-related settings.
Windows
When using Windows 8.1/8/7, driver settings cannot be changed while the monitoring function of
Windows is enabled. Disable the monitoring function (p. 48).
1. Exit all programs that are using the QUAD-CAPTURE.
2. Open the “Control Panel” and set the display mode as follows.
• Windows 8.1/8/7: Icon view
• Windows Vista/Windows XP: Classic view
3. Double-click the [QUAD-CAPTURE] icon.
4. From the “Driver” menu, select [Driver Settings].
The “QUAD-CAPTURE Driver Settings” dialog box will appear.
Setting Description
SAMPLE RATE
You can display the current sampling rate. To change the sampling rate, select a
sampling rate from the menu.
* The sampling rate cannot be changed during playback or recording, or when
equipment is connected to the COAXIAL IN (3/4) jack.
CLOCK
You can display the current clock source.
INTERNAL The internal clock is operating.
EXTERNAL The clock is operating in sync with the equipment connected to the
COAXIAL IN (3/4) jack.
* The sampling rate of the input digital signal is also displayed.
Audio Buer Size
You can adjust the input and output audio buer size.
Decrease the buer size to decrease latency. Increase the buer size if audio drops out.
* After adjusting the buer size, make sure to restart all programs that are using the
QUAD-CAPTURE. If using software that has an “audio device test” function, run the
test function.
[Use Multichannel
WDM Audio Port]
check box (Windows
XP)
You can use all audio channels via one WDM audio port by selecting this check box.
To use Cakewalk software, such as SONAR, with WDM/KS mode, select this check box.
* The modied setting will take eect after you turn the power of the QUAD-CAPTURE
o, then on again.
* If this check box is selected, you cannot use the WDM audio ports as 2-channel
(stereo) audio ports.
[Use ASIO Direct
Monitor] check box
To use the ASIO Direct Monitor function of ASIO-compatible software, select this check
box.