Owner`s manual
Introduction to the Studio Foundation Sound Recording Kits v.5 (Sp13)
Setting low cut and mic sensitivity
1
R-09
R-09HR
1
R-05
2
1. Turn the LOW CUT lter ON to eliminate low-
frequency rumble. Good when recording dialog since
it cuts low frequencies that are below the vocal range.
Sometimes intense low frequencies will throw o your
levels. Set the LOW CUT lter OFF when you actually
want these low frequencies in your recording, e.g.
recording low-frequency sound eects.
2. Adjust overall sensitivity with the MIC GAIN switch as
needed:
a. If audio levels are two high after adjusting the
input levels, set MIC GAIN to the L (LOW) position
to reduce the sensitivity of the microphone.
b. If audio levels are two low after adjusting the
input levels, set MIC GAIN to the H (HIGH)
position to increase the sensitivity of the
microphone.
2
2
1
4
3
2a
2b
13
Introduction to the Studio Foundation Sound Recording Kits v.5 (Sp13)
Display information during recording
1. Current le name
2. Time remaining for recording on SD card*
3. Elapsed recording time
4. Sampling Rate (not shown on R-09)
5. Limiter status (not shown on R-09):
on R-09HR displays: if on or if o;
on R-05 displays: if on, or if o.
6. Record-Standby / Record Status
7. Plug-in power status (not shown on R-09):
on R-09HR displays ON or OFF;
on R-05 displays if on or if o, but
only when external microphone is selected.
8. Current time of day
R-09 and R-09HR
R-05
3
1
2
2
3
4
5
6
6
7
7
8
8
1
* Most recorders in the cage have a 2GB SD card installed,
allowing for 166 minutes of recording time when the
recorder is set to sampling rate: 48 KHz and recording
format: WAV-16-bit. Note, however, that some recorders
have a 1GB SD card, so the recording time will be
reduced to 96 minutes when using those recorders.
14