Owner`s manual
Troubleshooting
102
Problems with Playback
Problem Cause Page
No sound
You might not hear the sound if the output volume is too low. Try gradually
increasing the output volume.
p. 62
Make sure that your headphones or speakers are correctly connected. p. 29
Can’t play back
Make sure that the le name is assigned correctly. The R-26 cannot use les
that have a name that begins with a “.” (period).
p. 73
The R-26 can only play les with a le name extension of .MP3 or WAV. p. 67
A damaged le cannot be played. You might be able to recover the le by
using the Repair function.
p. 80
When using the unit as an audio interface, you won’t be able to play projects
that have a dierent sampling frequency than the sampling frequency that is
set for the audio interface.
p. 89
Unintended les are
played
The le Play Mode might be set to shue playback (SHUFFLE). If so, the
R-26 will randomly select and play the next le. Change the setting back to
conventional playback (SEQUENTIAL).
p. 62
No sound heard with
preview monitor
Sound won’t be output while headphones are being used. p. 29
Could preview monitor be turned o in the SYSTEM SETUP?
Turn preview monitor on.
p. 97
When the input device is set as the internal mics in Audio Interface Mode,
sound will not be output.
p. 92
Other Problems
Problem Cause Page
Power won’t turn on
Make sure that the AC adaptor is connected correctly. If you’re using
batteries, make sure that they are oriented correctly, and not loose in the
compartment. If the batteries have run low, install fresh batteries.
p. 20
If the R-26’s power can’t be switched on even though there’s no problem
with the AC adaptor or batteries, it may have malfunctioned. Please contact
a customer service location listed on the warranty envelope.
–
R-26 is not recognized
when connected to
computer
If no SD card is inserted in the R-26, it won’t be correctly recognized by the
computer. If no icon appears on your computer’s desktop, make sure that
the SD card is inserted correctly.
p. 26
Display becomes dim
The display will be dimmed if no operation is performed during the
specied Display Timer interval.
p. 97