Owner`s manual

Connecting to Your Computer via USB
91
Overview Getting Ready Recording Playback File Operation Computer Appendix
2. Touch the desired sampling rate.
SAMPLE RATE
44.1 kHz
48.0 kHz
88.2 kHz
96.0 kHz
3. Touch <BACK>.
* The following screen will appear if you
change the sampling rate setting while
the R-26 is connected in audio interface
mode. Disconnect the USB cable from
the R-26, and then plug it back in again.
Connecting the R-26 to
Your Computer
1. Start up your computer.
2. Switch on the R-26’s power (p. 24).
3. Use the included USB cable to
connect the R-26 to your computer.
USB Connector
R-26
Computer
4. Select the mode (only if you’ve
chosen “SELECTABLE”).
If the USB CONNECTION (p. 84) is set to
“SELECTABLE,” a selection screen will
appear when you connect the R-26 to your
computer, allowing you to select either
storage mode or audio interface mode. For
this example, touch <AUDIO I/F>.