User Manual

Chapter 6: Appendix
57
6-2 Shaft Lubrication
The material may not cut properly if dust and material adhesive adhere to the cutting carriage guide shaft. If the following
symptoms are present, remove the shaft cover and lubricate the shaft located as indicated in the figure. Use a machine oil to
lubricate.
Procedure
➊
Unplug the power cord from the machine.
➋
Remove the shaft cover.
Use a Phillips head screwdriver to remove the screws.
➌
Wipe and remove dust adhering to the shaft.
➍
Use machine oil to lightly lubricate the shaft sec-
tion indicated in the figure to the left.
Using too much oil can cause the material to stain.
➎
Replace the shaft cover and screw into place.
It does not move smoothly You hear an abnormal noise