User`s manual

1-3
Part 1 Introduction
1.3 Setting Up the SX
Ground the unit with the ground
wire.
Failure to do so may result in risk of
electrocution in the event of a mechanical
problem.
Do not use with any power supply
other than the dedicated AC adapter.
Use with any other power supply may lead
to fire or electrocution.
Do not use with any electrical power
supply that does not meet the
ratings displayed on the AC adapter.
Use with any other power supply may lead
to fire or electrocution.
Use only with the power cord
included with this product.
Use with other than the included power cord
may lead to fire or electrocution.
Install on a stable surface.
Failure to do so
may result in the
unit tipping over,
leading to injury.
50 mm
(2 in.)
Installation Space
When cutting starts, the material moves forward and backward.
Do not place any objects within the area in which the material moves during cutting.
Do not place any object
within the area.
NOTICE
Never install this unit in any of the following situations, as it could result in damage:
• Places where the installation surface is unstable or not level.
• Places with excessive electrical noise.
• Places with excessive humidity or dust.
• Places with poor ventilation, because the SX-15/12/8 generates considerable heat during operation.
• Places with excessive vibration.
Use within a temperature range of 5 to 40°C (41 to 104°F) and within a humidity range of 35 to 80%.
Make sure the power to the computer and the SX-15/12/8 is switched off before attempting to connect the
cables.
Securely connect the power cord, computer I/O cable and so on so that they will not be unplugged. Otherwise,
faulty operation or breakdown may result.