User`s manual

2-8
Part 2 Performing Cutting
Set the cutting range.
If you are using the included material, make sure the
cutting range is set to the following values.
SX-15 : 340 mm (13.38 in.) (width)
270 mm (10.63 in.) (length)
SX-12 : 250 mm (9.84 in.) (width)
390 mm (15.35 in.) (length)
SX-8 : 160 mm (6.29 in.) (width)
270 mm (10.63 in.) (length)
* If you're using SX-12/8, width is a fixed value.
Click [OK].
The [Advanced Options] dialog box appears.
If you want to change the size, click [Add New Media
Size], and at [Media Size], enter the value for [Length].
In [Cutting Area], for [Length], enter a value larger
than the length of the data to cut.
To select an added media size, then after you add the
size, again display [Print Setup], go to [Media Size
List], and select the saved size. Simply adding a media
size does not make the driver select it.
5
Click [OK].
The [Properties] dialog box appears.
Click [OK].
6
The [Print Setup] dialog box appears.
Click [OK].
7
Choose [MediaSizeSettings], then click [Properties].
The [MediaSizeSetting] dialog box appears.
4