User`s manual

2-12
Part 2 Performing Cutting
Click , then click [OK] in the dialog box that
appears.
Data is sent to the SX-15/12/8 and cutting starts.
3
Before performing cutting, make sure the SX-15/12/8 has been prepared as described in the sections "2.1 Load the Material" to "2.2
Creating Cutting Data"
2.3 Starting Cutting
Close the front cover and press the [STANDBY] key.
1
The [STANDBY] LED lights up and the carriage moves
as shown in the figure, then stops.
2
STANDBY Key
STANDBY LED
When not in use for several hours,
unplug the power-cord plug from the
electrical outlet.
Failure to do so may
result in danger of
electrical shock,
electrocution, or fire
due to deterioration of
electrical insulation.