User`s manual

3-14
Part 3 Mastering the SX
Use a commercially available squeegee or a ruler to
remove moisture.
4
The larger the material is, the more difficult is it to apply while adjusting misalignment of the entire material, and the greater is the
likelihood that air bubbles will get trapped between the material and the application surface.
Applying detergent-containing water to the application surface makes it difficult for air bubbles to form and lets you move the position of
the material as you affix it.
Wipe away any dust or oil from the location where the
material is to be applied.
Use a commercially available mister to spray a generous
amount of water containing two or three drops of neutral
detergent to the application surface.
2
Prepare the cut material.
Affix application tape to the top of the material.
1
After you have removed all moisture, slowly peel off the
application tape.
5
Place the material on the application surface.
Adjust the positioning and angle of the material.
3
3.7 Applying Large Material