Owner`s manual

40
AUX, MTX, MAIN operations
AUX, MTX, MAIN operations
• ATT (Attenuator)
This adjusts the input level.
• EXT FX INSERT (External Effect insert)
These ports let you use the rear panel INPUT17–20 and
ASSIGNABLE OUTPUT 7-10 ports to insert external effects
processors.
• FX INSERT (Effect insert)
These ports let you insert FX1–FX4.
• GEQ INSERT
GEQ1 to 4 can be inserted at this point.
• COMPRESSOR
This is a dynamics processor that can be used as a
compressor.
The compressor and limiter cannot be used concurrently.
• 4-BAND EQ
This is a 4-band EQ with LO, LO-MID, HI-MID, and HI
frequency bands.
• FADER
This adjusts the output level.
• BALANCE
This adjusts the left/right balance for MAIN L/R or for stereo-
linked AUX/MTX buses.
• MUTE
This mutes the output of the channel. The post fader sends
to the MAIN L/R bus and MTX buses will also be muted.
• LIMITER
This limits the output level.
The compressor and limiter cannot be used concurrently.
• MAIN SEND (AUX1–8 only)
This adjusts the send to MAIN.
• MTX SEND (MATRIX send)
This adjusts the send to MTX1–4.
• DELAY
This delays the output signal.
• SOLO
This outputs the selected signal to MONITOR OUT L/R and
PHONES OUT.
1.
In the LAYER section, press [AUX/MTX] to assign the
output channels to the fader module section.
2. In the fader module section, press [SEL] to select the
desired input channel.
3.
In the CHANNEL EDIT section, press [EDIT].
The CHANNEL EDIT screen appears.
Pressing a different [SEL] button while the CHANNEL EDIT screen is
displayed lets you switch to the view for that channel.
At the CH-SELECT OPTION screen (p. 94) in the user preference
settings, if “CH-EDIT FOLLOWS [SEL]“ is in effect, pressing [SEL]
accesses the CHANNEL EDIT screen for that channel.
Accessing the CHANNEL EDIT
screen
M-200i_e.book 40 ページ ２０１３年６月２８日 金曜日 午後１時２７分