Owner`s manual

AUX, MTX, MAIN operations

Attenuator

ATT knob

This adjusts the input level of the channel in a range of -48.0

dB to 0.0 dB.

Overload indicator

This will light when the output of the attenuator exceeds the

OVER LEVEL setting specified in the METER FUNCTION screen

(p. 59).

Balance

This adjusts the left/right output balance for MAIN L/R or for

stereo-linked AUX/MTX buses in a range of L63 to R63.

DELAY

DELAY button

This turns delay on/off.

Delay time

This adjusts the amount of delay in a range of 0.0 ms to 400.0

ms.

COMP/LIMITER button

This turns the compressor or limiter on/off.

For information on editing compressor or limiter parameters,

refer to “COMPRESSOR/LIMITER screen” (p. 49).

The compressor and limiter cannot be used concurrently.

EQ graph

This shows the approximate response of the EQ.

EQ button

This turns the 4-band EQ on/off.

For information on editing 4-band EQ parameters, refer to “4-

band EQ operations” (p. 55).

TO MAIN (AUX only)

PAN

This adjusts the panning of the audio signal sent to MAIN L/R

in a range of L63 to R63.

MAIN button

This turns the send to MAIN L/R on/off.

Faders

This adjusts the output level in a range of -Inf dB to +10.0 dB.

CHANNEL EDIT screen

Normally, you should leave the attenuator set at 0 dB.

When the input of an AUX, MTX, or MAIN is overloaded,

however, you can use the attenuator to avoid overload.

M-200i_e.book 41 ページ２０１３年６月２８日　金曜日　午後１時２７分