Owner`s manual

GATE/EXPANDER screen

In the fader module section, press [SEL] to select the

desired channel.

In the CHANNEL EDIT section, press [GATE].

The GATE/EXPANDER screen appears. (The name of the

screen varies depending on the type of gate selected.)

ON button

This turns the GATE/EXPANDER on/off.

IN meter

This shows the input level of the gate/expander. This shows

the level of the key-in signal when the KEY-IN FILTER is on or

the KEY-IN SOURCE is not SELF. For stereo-linked channels,

two meters (L and R) are shown.

GR meter

This shows the amount of gain reduction for the gate/

expander.

OUT meter

This shows the output level of the gate/expander. For stereo-

linked channels, two meters (L and R) are shown.

Parameter

This sets the parameters for the gate/expander.

The parameters differ according to type.

Gate

fig.PopGateGuide2.eps

THRESH knob

This adjusts the threshold level in a range of -80.0 dB–0.0 dB.

RANGE knob

This adjusts the RANGE in a range of -Inf dB–0.0 dB.

ATTACK knob

This adjusts the ATTACK time in a range of 0.0 ms–800.0 ms.

This is the time from when the input signal exceeds the

threshold level until the gate opens completely.

RELEASE knob

This adjusts the RELEASE time in a range of 0 ms–8000 ms.

This is the time over which the gate reaches its maximum

effect after the HOLD time has elapsed.

HOLD knob

This adjusts the HOLD time in a range of 0 ms–8000 ms. This

is the time from when the input signal falls below the

threshold level until the gate begins closing.

GATE/EXPANDER screen

M-200i_e.book 45 ページ２０１３年６月２８日　金曜日　午後１時２７分