Owner`s manual

48
GATE/EXPANDER screen
GATE/EXPANDER screen
The key-in signal used by the gate is taken from the post-HPF
point of the channel itself or from any of the following sources:
• CH1-32 direct out
• AUX1-8, MTX1-4, or MAIN L/R output
• REAC INPUT1-40
• INPUT1-24
You use the KEY-IN SOURCE screen to select the key-in signal.
1.
Access the GATE FUNCTION screen.
2.
Select “KEY-IN SOURCE“ and press [ENTER] to access the
GATE KEY-IN SOURCE screen.
3.
Use the value dial to move to the desired channel and
press [ENTER] to select the channel to use as the key-in
signal.
1. Access the GATE FUNCTION screen.
2.
Select “KEY-IN FILTER“ and press [ENTER] to access the
GATE KEY-IN FILTER screen.
IN meter
This shows the input level of the gate/expander.
This shows the level of the key-in signal when the KEY-IN
FILTER is on or the KEY-IN SOURCE is not SELF.
For stereo-linked channels, two meters (L and R) are shown.
GR meter
This shows the amount of gain reduction for the gate/
expander.
OUT meter
This shows the output level of the gate/expander. For stereo-
linked channels, two meters (L and R) are shown.
KEY-IN source
This shows KEY-IN source.
Filter graph
This indicates the approximate response of the key-in filter.
SOLO button
This lets you hear the key-in filter’s output signal via the
unit’s monitor output.
ON button
This turns the KEY-IN FILTER on/off.
TYPE
This select the filter type.
FREQ knob
This adjusts the center frequency in a range of 20 Hz to 20.00
kHz.
Q knob
This adjusts the Q of the peaking-type filters in a range of
0.36–16.00. Higher values produce a sharper curve.
Exiting the GATE KEY-IN FILTER screen automatically turns off
key-in solo.
Selecting the key-in signal
HPF
COMP
ATT
KEY-IN
KEY-IN
SOLO
TO SOLO
GATE/
EXP
KEY-IN
FILTER
- SELF POST HPF
- CH 1-32 DIRECT OUT
- MAIN L / R
- AUX 1–8
- MTX 1–4
- INPUT 1–24
- DOCK INPUT L / R
- REAC INPUT1–40
Using the key-in filter
1
2
3
4
5
6
7
8
9
10
M-200i_e.book 48 ページ ２０１３年６月２８日 金曜日 午後１時２７分