Owner`s manual

COMPRESSOR/LIMITER screen

Access the COMP FUNCTION screen.

Select “KEY-IN FILTER“ and press [ENTER] to access the

COMP KEY-IN FILTER screen.

IN meter

This shows the input level of the compressor.

This shows the level of the key-in signal when the KEY-IN

FILTER is on or the KEY-IN SOURCE is not SELF.

For stereo-linked channels, two meters (L and R) are shown.

GR meter

This shows the amount of gain reduction for the compressor.

OUT meter

This shows the output level of the compressor. For stereo-

linked channels, two meters (L and R) are shown.

KEY-IN source

This shows KEY-IN source.

Filter graph

This indicates the approximate response of the key-in filter.

SOLO button

This lets you hear the key-in filter’s output signal via the

unit’s monitor output.

ON button

This turns the KEY-IN FILTER on/off.

TYPE

This select the filter type.

FREQ knob

This adjusts the center frequency in a range of 20 Hz to 20.00

kHz.

Q knob

This adjusts the Q of the peaking-type filters in a range of

0.36–16.00. Higher values produce a sharper curve.

Exiting the COMP KEY-IN FILTER screen automatically turns off

key-in solo.

You can select either compressor or limiter on AUX1 through 8,

MTX1 through 4, and MAIN L and R.

The insert point varies according to the type selected.

Access the COMP FUNCTION screen.

Select TYPE SELECT and press [ENTER].

COMP/LIMITER TYPE SELECT screen appears.

Select COMPRESSOR or LIMITER as the compressor type ,

and press [ENTER].

The type changes.

Using the key-in filter

Changing between COMPRESSOR/

LIMITER

M-200i_e.book 52 ページ２０１３年６月２８日　金曜日　午後１時２７分